Extra height stacker kit for V2 MTB shim

£16.00

Sold out

SKU: FP-V2STAC4-SK

Stack height

4/6mm kit

8/10mm kit

Product variants

Quantity

Modular clip-on compatible with the V2 shim
Sloped front to facilitate easy clipping in
Tough glass filled nylon

Description

The FORM stacker kit system is designed to extend the height of the V2 walkable MTB shim to accommodate stack height requirements above the standard 3-6mm range. The kit replaces the standard 2mm stacker that comes with the shim with an extended height stacker PLUS an optional additional 2mm clip-on spacer set.

Kit 1 will provide between 7-10mm when combined with the base 3mm shim and 1mm spacer.
Kit 2 will provide between 11-14mm when combined with the base 3mm shim and 1mm spacer

*Please note: This kit can NOT be used alone. This should be used in combination with the V2 MTB shim, which needs to be purchased separately.

Technical info

Due to the size necessary to provide sufficient stability for a taller stack this stacker requires a "clean" flat surface front to rear without any raised rubber areas. In the case of raised rubber areas there are ways to get round the problem, however a flat surface is best. Please contact us with any queries about this.

The 4/6mm stacker measures:

70mm front to rear
35mm from the cleat bolt holes rearward
38mm wide

The 8/10mm stacker measures:

74mm front to rear
35mm from the cleat bolt holes rearward
38mm wide

Kit includes:

4/6mm kit (7-10mm total): 4mm stacker / 2mm spacer set / cleat plate / shim screws / cleat screws
8/10mm kit (11-14mm total): 8mm stacker / 2mm spacer set / cleat plate / shim screws / cleat screws